I have had a Bachman Santa Fe Engine for 3 years.  All of a sudden it has stopped working.  There is power in the track, as the engine light works.  I have taken it apart and cleaned it , but still no power to the wheels?  Any help would be appreciated.  Thanks!

I have a Bachman EZ Command Control center.  I presently run 2 trains, and attached a power switch to it.  Works great.  My question is can I hook up signals to this, or do I require a separate controller?  Thanks!

I have a 2 bachman train sets.  No problems until i try and run the cars on a hill.  The couplers keep detaching from the engine.  Can anyone suggest the best couplers to buy so that they are not continually detaching?  Thanks

I have buit a few tunnels and trestles.  The cars keep disconnecting from the engine when I go up grade.  What kind of couplers are the best for grade?  Any other suggestions to keep the cars connected would be helpful. Thanks!

I have a Bachman Santa Fe Engine.  It is very noisy and sounds like grinding gears.  Is there anyway of fixing this?  Thanks very much.

I am trying to do double track, but cannot figure out how to get the power over to the other track from the power track.  Do I need another rerailer, that would plug into the existing one?  Any help would be appreciated.  Thanks!

I am trying to do double track, but cannot figure out to get the power over to the other track from the power track.  Do I need another rerailer, that would plug into the existing one?  Any help would be appreciated.  Thanks!

I am extending my layout and would like to know how much length of track can one EZ Command Control Center Power?   Thanks very much!

I have the DCC Command Center and the Bachman Power Pack and Speed Control.  However I cannot figure out how to connect the remote switches.  The Controllers are connected fine.  Can anyone let me know the step by step instructions to get
these switches working?

Thanks!

I have recently purchased the Digital Commander deluxe set.  I am trying to add remote turnouts, but cannot get them to work.  Yes I am new to Model Railroading, but retired with 37 years at CPRAIL.  I checked
you tube but the fellow says to push a button on the turnout, and then function 9 on the controller. However my Bachman remote turnouts have no button to push?

Can anyone help me step by step to get these turnouts to work?  All I get is the controller flashing and beeping.

Thanks very much!