Hope someone can come to my rescue here! I have a Bachmann 4-6-2 light Pacific DCC w/ sound NYC 4552. One of my helpers? decided to try and repair the harness and in the process tore all the wires from the connector. This is a fairly new loco, so is there a way to get the pinout of the connector from the factory or am I going to have to try to  read all the connections coming from the loco? If that is the case, what should the motor read in ohms and how can I distinguish the + and common of the light. Also, is there 1 contact that is not used? Any and all help would be greatly appreciated

Also, is pin1 on the left or right?





Squirls b crazy

I picked up some leds from Bachmann that are universal, but haven't found any specs on them in regards to voltage and color coding on the wiring, hookup info. Any help? the wires are yellow and white

I recently replaced a motor in a dcc/dc 2-6-0 with an unknown history. I thought I got all the wiring correct, but the lighting and motor are backwards in regards to the programmed sound, I reprogammed the chip so the motor directions are backward and cv 33 and 34 so the lighting forward and reverse stays on in both directions when I run DCC. I will mostly be running this on DC and all the programming changes made no affect on the dc running. .......any ideas?? thanks, guy

where can I get replacement brushes for the old style Brill motor OR would it be wiser and more economical and possible to change it to the newer can motor/power truck combo?