Hello all--

Am having a problem with my E-Z command control center.
After plugging in and turning on power, all is normal--#1 is on, under stop is on and direction is on--then, after plugging into track all lights star flashing and function goes back to #1--

Have checked track for obstructions, don't knw where there might be a short--have no ideas. 

Any help ??

(Was working right before)

How tight will a flex track bend ?  I need to make a "U Turn/ turn around" on a board 30 inches wide. Am using Bachman EZ-Track and would like to stay with that if possible.