Hi,

recently bought a White Pass Annie with some cars. Unftly. one of the trucks of one car is broken at one side. Is impossible to glue. Where can I get spare parts for that?

cheers

Jan

Hi, I am planning to connect the Chuff sensor board of my 2-6-6-2 to my Uhlenbrock Intellisound modul.
The question is, which voltage the chuff sensor-board needs. The Uhlenbrock has connectors for GND 3,3V and input. Is it possible to just take the chuff signal from the mainboard? Or do I have to rewire the complete system? As far as I know, I need the signal - . Is the Signal the board gives - or + ?

Thanks for your help

Jan

Unftly. a small part of my new Bachmann 2-6-6-2 body broke. Which glue is needed to fix that?

Thanks in advance for your help.

Jan

Hi,

I recently purchased a Baldwin 2-6-6-2, and equipped it with a DCC decoder by Uhlenbrock, Type 77500. I used the supplied connector and connected everything like suggested.
Everything worked nicely, but the lights didn't react. No light, no firebox, regardless of the switch positions. The decoder settings are correct.
What can be wrong here?
If I want to connect the lights directly to the decoder, are the resistors for the LEDs on the mainboard, or can I connect the LEDS without additional resistors?

Thanks from Germany for your kind help.

Jan