Has anyone installed a QSI DDC controller in a Connie? I had St Aubin install one in my K-27 and want to stick with the same board for the Connie.

I'm new to DCC and would like to stick with the same board in both to decrease the learning curve.

Thanks,
Jim

I'm redesigning my indoor layout to accommodate the new K-27 and need to know what the minimum diameter curve it can use? I really only have room for 8ft curves but 9s are a possibility if necessary.

If you have run in on 8s how bad is the overhang and can the body mounted couplers be used? Currently the rest of my 1:20.3 rolling stock is AMS with body amounted couplers.

Thanks
Jim