All,

I was wondering if the e-z track manual and remote type turnouts would work without shorting when using dcc to power the track?  Don't want to fry my new dcc system, lol.

Thanks in advance,

Chuck S

All,

As the topic line implies, I was wondering if a drop in sound decoder with speaker for the Bachmann DCC on board GS4 4-8-4 locomotive exists?

Thanks in advance,

Chuck S

My brand new GS4 4-8-4 SP Daylight locomotive (DCC equiped) ran fine for about 20 minutes.  I was very impressed with its ability to start at a crawl.  Anyway, the loco started to stall whenever it would exit a curve.  At slower speeds it would stop totally.  At higher speeds, the loco would clear the curve and resume travel.  I did not notice any flickering lights.  The lights would remain on when the loco was completely stopped.  I then ran the loco in reverse with no problems. 

I am using DC.  Before I ran the loco I removed the decoder and installed the dummy plugs.  My EZ track is brand new as well.  Anyone have any similar problems?

Thanks in advance,

Chuck S

Hi,

I just received a brand new, straight out of the box combo pack of EZ track and a DC controller.  The controller feeds full power to the track no matter where the "speed" dial is located.  Is there a way I can troubleshoot this problem before I contact customer service?  I ran a few different locomotives with the same results.

Thanks in advance!

Chuck S