Hello, i serching for an technic to remove the decals (graphics) on loco tender.

Tank's
Luc

Hello, i serching to buy this engine (Roundhouse EMD Model 40) i found one shop but they sale only in USA.

Tank's
Luc
from Canada

Hello i have a problem with my controler, i lost the signal, the signal guage goes up and down and i totaly lost the control of the engine. I try it at any distance 1 feet to 8 feet.

Luc

Hello, i recently buy an Dynamis controler and bachmann 2-8-0 with sound, i would like to know if i can use all sound fonction buy now i can use only 9 sound fonction.

Luc

Hello, i would like to know if i can used an atlas under table switch machine with walters dcc-friendly turnouts.

tank's

Luc

Hello i planed to buy an software (model builder) from evan designs but i am not sure if it's work with Windos vista...Luc

Hello, yesterday during a short circuit i lost an engine, my dcc controler did not see it, i try to reprogram and nothing, i try to use it with analogue systeme and it's work but since the sort.. it refuse to work on dcc,

wath's wrong with this engine .......

Luc

Hello,
I planed to buy an MRC Ho scale synchronized sound DCC decoder (steam) 8 pin plug, with my DCC steam engine (8 pin plug) i used an Bachmann EZ command, can i used it right from the box.

Luc

Hello,
I am a newbee in model rairoading and i built an small layout (4x8) i used easy command from Bachmann with 4 dcc engines, the track came from life like power lock, my brobleme came with the switch all my engine turn to short circuit when goes backward on every switch, how can turn this trouble off.

Luc

Hello,
I ready to install an bachmann decoder in my Bachmann 2-10-0 and i serching for an cennection diagram, because i open the tender and i can't see where can solder the wire of decoder.

Luc

Hello,
I just recive my new IHC 2-10-2 DCC ready with 8 pins plug can i directly install an bachmann 8 pins plug decoder on it. (i used an bachman easy control)

Luc

Hello,
I buy an Bachmann russian 2-10-0 an i try to pull more than 5 wagon with it and the engine looks like missing pulling power, it is normal, i pulling more than 8 with my old ihc 0-8-0.

tank's for help.

Luc

Hello, i planed to buy an Proto 2000 SW-8-900 with factory installed DCC and sound, i want to know if i can use this out of box on my DCC layout with all the fonction (sound etc..) i use Bachmann EZ command.
Luc

Hello,
In my instruction (Bachmann EZ Command) it said control direction, light and sound) (SOUND!!!) it is rigth.

Luc

Hello,
I have an 0-8-0 from IHC (Premier) and i would like to know if it's possible to turn it to DCC to use with my (BachmannEZ command) and how can do this.

Luc

Hello,
I would like to instal an decoder(Bachmann) in my Bachmann H-16-44, i just want to know if it's possible and how.(i use Bachmann EZ command)

Luc

Hello, i am a new in DCC,i have an Bachmann HO 0-6-0 saddle tank switcher and i would like to know who is the smalless decoder can i instal on it to use with my Bachmann e-z command system.

Luc