On the 4-6-0 anniversary edition, there are small screws holding the pilot rail to the pilot. How do you install those little screws? A nut driver would be good but I can't figure out what size I would need. I'm afraid that using needle nose pliers would result in the screws flying all over the room.

I am working on a C-19. The headight kept failing and now seems quite dead on both the DC and DCC positions. I want to get to the switches behind the smokwbox cover and the circuit baord behind it to find out where the system is failing. Do I habe to pull the whole boiler to do this?

I am working on a new Large Scale DCC equipped locomotive. I need to disable the ability to run on DC. How do I do that?

I have a 2-8-0 that has never been run. I just unpacked it and hooked up the tender. I connected a power pack to it and turned on the power. The drivers are binding at 3 spots in each revolution. I stopped it when it bound up. Looking at the left side, it is obvious that the #3 driver is out of quarter from the other 3 drivers. What can be done about this?

I have been working on a K-27 (Installing radio control). It appears that this engine has the dreaded counterweight problem. I can not find them as replacement parts. Are they no longer available? Are they the same as the ones on the 2-8-0?

I have a G scale Bachmann Annie 2-6-0. I need a new tender trailing truck. The coupler got broken off of my engine.

What voltage does the smoke unit operate on? I mean the voltage actually applied to the smoke unit, not the track voltage.