Any suggestions on a track layout program for IPad?

Mr. Bachmann, is 24" radius EZ track available in bulk? or will it ever be in bulk?

If I put a DCC decoder in a DC FT-A will it run at the same speed as my DCC FT-A? Can I run them in a consit using a Bachmann DCC controller?

I am in the process of designing a new layout on a 6'x12' table using ez-track only. It appears that the largest radius sold in bulk is 22"; my question is will 22" work for "most" Spectrum loco's. I am planning on modeling the 1950's to 60's? I really don't want to buy track 5 pieces at a time.

I am looking at buying one of these any feed back positive or negative?

Does anyone know of a software that utilizes Bachmann EZ track sections?

 This is a link to pictures of my current layout; now remember when the kid leaves this summer He takes the couch and I get the whole room. It can hold about a 9 foot by 13 foot 6 inch table. That why I have been looking and asking about bigger layouts and bigger radius curves.    http://pbckt.com/sL.Rq3

How do i post a picture on the form?

OK, I have been running a fairly large layout that has a double loop with no yard space to speak of. I  now think I am ready for a more complicated layout. I have been looking at the Atlas HO 36 the Oregon Pass Lines. With all that said here is my question; have any of you more experienced modelers done this layout or something similar and the book I have only shows wiring for DC. Any DCC suggestions?

I have read alot of posts about min radius; My question is this. When someone says that a 22" min radius will work best for a specific engine or specific length passenger car are they talking about realistic appearances or are they saying the engine or car won't work at all? 

I have several ? about connecting flex track. Do you have to remove one of the ties to get the rail joiners to fit? When curving the track does it matter which side of the track you put on the inside of the radius?

I have installed a siding between two tracks running in the opposite direction. I was hoping to use this siding to change the direction of the trains. I ended up with a short; so I isolated the siding supplied separate power leads and still have a short. Do I need to install a reversing module and if I do; do I have to install a booster in line with the reversing module? Oh ya I am running Bachmann E-Z Comand DCC.

I am using all Bachmann E-Z track on my layout. my question is this-- will 18" radius curves work with all sizes of rolling stock and engines?

Everyone knows by now that I am new at modeling; so here goes. If you are running a FT-A and a FT-B together on the same train and both are powered how do you knon they are running at the same speed? is one pushing or pulling the other?

I just opened and set up my new Digital Commander Train Set to get the feel for how the digital control works. i know that the loc's with this set are not the high end DCC equipment that i want to eventually run; but i thought this would be an easy and cheap way to get started with digital control. the FTA runs smooth and quite at very low speeds and high speeds. the EDM GP40 has a grinding electrical surging sound at low speeds/seems to run fine at higher speeds but still not as quite as the FTA. any ideas or input.

can you solder power wires to ez track from the buss or do you have to use the ez track terminal? if you can solder has any one had any luck / is there do and don'ts specific to ez track?

I am fairly new to the hobbie and as i was reading some of your posts on DCC controller ?'s i saw that you were saying something about twisting? or turning the bus wires. please explain what you mean.

Do I need to use a booster for a layout that has two 20ft tracks running 3 loco's? Bachmann EZ Command