Does a Bachmann Spectrum 2-8-0 use more voltage with the decoder installed for forward motion, then without the decoder installed?Thanks Wally

When you run a Bachmann DCC equipped engine on a DCC equipped track, do you need to reprogram the engine to run on DC again? Thanks Wally

Will the Bachmann HO engines with DCC run just as well running in DC? I am thinking of buying DCC engines and running them using DC and a MRC synchro sound unit for sound, untill the budget allows for a DCC unit and sound equiped engines.Thanks Wally

Will the Bachmann HO engines with DCC installed run with a dc transformer?

Will the MRC Synchro Sound black box with the speaker work with the Bachmann DCC Comand control unit. I know the mrc unit has at least 2 wires that go to the acc. terminals on a regular transformer . I do not know if the Bachman DCC unit has terminals like that. Thanks for the help.

Will a 4-4-0 handle a 15 inch radius curve? Is there any steam engine that will handle that small a radius?

I need some advice as to any diesel or steam engine that will handle 9 inch radius curves. I would like to build a shelf type layout 11 feet long but as narrow as possible. Would 11 inch radius make a great difference? Any listing would be a great help. Thanks Wally

Mr.Bachmann
    Can you use a digitrax sound bug with the decoder that came in my Bachmann 2.8.0? Can you please tell me where the decoder is installed in the Bachmann 2-8-0? Thanks for your help.

Will the dynamis run dc engines? Is ther a special transformer needed? Will it work with on30? Any help appreciated.

I have some Bachmann train sets I would like to sell, is it allowed on this site. Thanks Wally

I have a nce power cab for my Bachmann ON30 engines. It does not support dc engines. Can I use a dpdt toggle switch and run a regular dc transformer through it and switch between dcc or dc on the same track.Thanks Wally

Is there a chip that will just plug in to the Bachmann on30 climax that does not have sound,just motor control? Help would be greatly appreciated.

Can someone please give me the length of the Bachman 4-4-0 on30 engine and tender?  And the heighth of the engine at the stack.  Thanks, Wally

I have some kato manual switches, and I am having trouble with a Bachmann Shay stalling on the switches.There are 2 ways you can set the switch, power and none power. It says to use non power routing for dcc, Powered routing can cause a short if the closed line of the rail touches the open line. If I tried the closed line would that help the stalling, or is there another way to stop the stalling with the Kato switch. Thanks foe any help. Wally

Has anyone tried the Kadee 148 couplers in there Bachmann on30 cars and engines? Is there any advantage to the # 5 coupler compared to the 148?  Should I stay with the couplers that come with the cars? Any help appreciated. Just getting started. Wally

I am new to DCC and have a question about the Bachmann on30 climax. What type of decoder do I need to have both sound and control? Do I need to solder for installation, or is there one that just plugs in? Any help greatly appreciated.

Will the new Forney handle 18 inch radius curves? Thanks Wally

How does the E-Z Command system work with the Bachmann on30 engines with Tsunami sound? Has anyone had experience with this?Thanks Wally

Will the ez command system work all of the sounds on the new Bachmann engines with sound installed? Any help will be appreciated.Thanks Wally

Will the Bachmann DCC E-Z digital command control system work with  Bachmanns own G scale engines that come DCC ready?