I am operating a ez command system dcc with a 5amp booster.After running it for a while, I shut it  down.
The next day I turned it on but I have no power to the tracks. I checked for shorts on track,none.I checked power to command transformer,it comes in,but not out to the track.
However this system is connected to the 5amp booster.I checked that and I have power going in but again no power to the track
What am I missing??

Pete

I have a GP-30 with dcc and sound with a strobe light and would like to find a wiring diagram as my front light and strobe won't light. the bulb is ok.

I have to replace my BAC#44605 transformer. Is there a replacement for this?

Does the bachmann ez command wireless system #36505 allow you to change cv functions and have f28 functions?

I would like to replace my ez command setup with a better system.I'm looking for something inexpensive and EASY to use.I have a 5amp power booster(Bachmann) I still want to use. I also want to still plug in my dc controller into the new system so I can still run dc loco's

I have a HO Acela with dcc on board and would like to add sound.
What would be the best and easiest speaker to use and where would be the best place to install it

I have a Berkshire 2-8-4 with dcc and sound. It came dcc equipped .I installed sound. It runs and works fine except when it crosses a particular switch.It has no trouble with the other switches. All other engines,whether dc or dcc cross it fine with no stop and go. I have to believe its something in the berkshire engine. I'm looking for ideas.

I have a doodlebug DC with a cracked gear in the power truck.Since Bachmann is sold out on these,does anybody know what is a substitute truck or gears that may be used?

I have a bachmann DC doodlebug that the motor has died.I would like to replace it I believe it's a single can motor.what motor do I need to replace it?

Can you or has anybody run 2 power boosters on the same layout?

I am running DCC command with a 5 amp power booster and when I check my track voltage it is only approx 9 volts. Why not 12?

I have a Acela train with dcc on board,no sound, that has been running perfectly  for 2+ years. All of a sudden it stopped working. I have checked the track with other engines and everything is fine.Before I take it apart,any suggestions as to what to look for?

I have discovered that the 12volt output is not working to the track. There is a switch to change this to 14volt.Has anybody done this for ho track ?
Bachmann does not repair this item, so I am forced to purchase a new one.

I have a 70 ton 3 truck climax that I think could run faster than it does. Is there a way to increase factory speed,and how do you do it?

I have a Bachmann diesel fp40 with dcc and would like to add sound. what should I buy to do this and how to install it.

I am using the ez command system at the present time #44902 and would like to upgrade to a larger system like the dynamis system.
Any ideas?

I have a dcc switch running on the ez command system. I have programmed it according to the instructions and it works the first time I turn power on.
That is push #9,then function,then I use #3 to switch it.After I run any other engine on another 3(2or4etc) then come back to switch it,it doesn't work.

Help

I purchased a #6 turnout and followed the directions.Everything programmed as it was supposed to but,the switch does not toggle back and forth when I hit either direction button.

I have no directions on how to operate them

I have a #44561RH &#44562LH DC switches that only work in one direction. I have changed the control but no difference. Are the motors bad or what.