New to DCC and this forum.
In a nutshell, I bought a DCC onboard Bachmann RS3, GP9 and (2) FA2 DCC and Sound engines. I initially successfully programmed each with a 4-digit address but being new to my Digitrax DT402 throttle usage I unknowingly apparently changed CV values somehow with (3) of the (4) engines trying to get back to square one because all were on the main at the time (yeah, I know....won't make this mistake again). I've read through previous posts here and saw mention of all Bachmann decoders factory reset is CV8=8 which I set all (3) engines to. I have 4 digit control again but now when I advance the speed control on the DT402 I have to bump it up to 6 or 7 before the engines(s) will start moving....which wasn't the case out of the box.
What else do I need to do please?
In a nutshell, I bought a DCC onboard Bachmann RS3, GP9 and (2) FA2 DCC and Sound engines. I initially successfully programmed each with a 4-digit address but being new to my Digitrax DT402 throttle usage I unknowingly apparently changed CV values somehow with (3) of the (4) engines trying to get back to square one because all were on the main at the time (yeah, I know....won't make this mistake again). I've read through previous posts here and saw mention of all Bachmann decoders factory reset is CV8=8 which I set all (3) engines to. I have 4 digit control again but now when I advance the speed control on the DT402 I have to bump it up to 6 or 7 before the engines(s) will start moving....which wasn't the case out of the box.
What else do I need to do please?