Could anyone help as I am new to doing this.  I have a EMD GP40 and have purchased a decoder board to make it run on dcc, it was supplied from Bachman but did not come with any directions as to where each wire is connected too, if you can help or advise me where I can get a diagram of how to connect it I would be very appreciative.
Many thanks Graham

Thanks for your reply Richg, the answer to you first question is NO, I have just started using with DCC

I have a Bachmann EMD GP40 Diesel Locomotive whih does not have DCC or SOUND.  I wish to install DCC or DCC & SOUND but do not know what PC Board I need, if you can help me with a part number and where to purchase from it would be appreciated

Dear Doneldon
Many thanks for your reply and the information you have passed on to me, at least now I know where to place my questions
Regards Ducky

Dear Jim
Thank you very much for your informative reply.  I am going to try the Digitrax DH123 and see how I go. In the future I will probably purchase locos that are DCC ready.  Once again thank you very much
Graham

Dear Doneldon
Sorry about using it on this Discussion Board, this was my first enquiry, is it better to us a General Discussion  or the other I used being HO.
Many thanks for the inromation on using DC losos on DCC

I have just started building my first layout and will be fitting it with a Digitrax System.  The engine that I purchased is a Bachmann EMD GP40 and I have been advised that it will not run on DCC.  As I am new to model railroading I would appreciate any advise that I can get on how to fit DCC to the loco and what type of DCC I would need

I have just started building a train layout and fitting it with a Digitrax System, the engine that I purchased is a Bachmann Diesel EMD GP40 and I have been advised will not run on DCC. As I am new to model trains I would appreciate any advise as to fitting the loco with DCC and what I would need to purchase to make it run on DCC.