Ton, Thanks for responding. Excuse my ignorance, but what is back EMF?

I have a Baldwin 4-6-0 that currently runs DC only. What type of non-sound decoder would be easiest to install?
Bill

I received my gears this past week. Using the instructions and pictures provided by Larry, I was able to get the trucks disassembled BUT can not get the clips off the drive shaft. I know where the clips should be, but do not see any place to press on the clip ends. I have looked through a magnifying glass and can not see the clip ends on the inside of the axle.
Has anyone else run into this problem?
I guess the only thing left to do is to send the loco into Bachmann and have them replace them.
Bill

I tried sending a couple small pictures, but it said the upload folder is full!?

I am replacing the drive shaft on my Shay and have run into an issue.
I followed the pictoral on the Railroad Line Forums showing how to release the clips.  On the
back side of the clips, I only see two holes with no prongs to press in to release the clip. I have pushed
into the holes with no luck of releasing anything.
Has anyone run into this issue? Any suggestions? 
THanks,
Bill

I just received a brand new On30 4-6-0 from a dealer on Ebay today. The lights and sound works fine when I use Channel 03, but no movement at all!  I have a Digitrax DCC system and other locos run fine.
Anyone have this problem? Any thoughts on what to do before I send it back?

Bill