still no luck handset screen is still frozen is there a way to reset handset?

I have a brand new dynamis unit and started using it to address my engines about 2 days ago
I finally mastered the art of programing and on the third engine I turned the handset off and back on and the screen is frozen on the overview screen and the command station is blinking the lefthand green led.
i unplugged the power line and the track line, changed the batteries and there is no change.
what happened? is this a know problem or is the unit dead? less than 3 hours on the unit while figuring out how to program.   

how do I turn on the lights?

I have a new dynamis unit and the instructions are about as clear as mud
Is there any other place to get step by step instructions on how to use this unit?

I just purchased 2 Bachmann steam engines
A 4-4-0 Union Pacific and a 4-4-0 Central Pacific Jupiter
Has anyone installed a decoder in them/
Did you have any Problems and what decoder did you use?

Is it possible to to program all my engines with the dynamis alone then add the booster without having a dedicated program track?
Where is this information documented?
I hate to keep asking questions about simple things that should be in a manual
If it were documented I could make a educated decision about which product to use than going by possible misinformation

Will the instruction to connect the units be in the manuals of both units?
I have looked at youtube and there are no videos on using the pwr supply with the dynamis

Will the 5amp booster and the dynamis controller work together and are there any drawbacks using them together?

can the 2 units be tied together?
I have the ez command unit and the dynamix operates 2.5 amps if combined will it operate 3-4 engines?

Is it possible to use 2 or 3 digit addresses in the ez command?

By the way
Im a old fart I dont have a MP3
I still use my Sansui and Bose 901's

That sounds like the info I need thanks for a fast responce

Where can I buy or find a wiring diagram for the EZ command connection wires?
I also need a cable to tie my dc to dcc together.

Its called wire glue
Its a water based glue with a concentrated amount of metal that makes a electrical connection
I havent tried it yet but will get back with results later.
Go to this ebay link

http://www.ebay.com/sch/i.html?_trksid=p2050601.m570.l1313.TR11.TRC1.A0.Xwire+glue&_nkw=wire+glue&_sacat=0&_from=R40

I am using older HO track that's about 40 years old and after a good cleaning I find that the connectors are quite loose causing poor contact between the track sections.
I didn't want to solder each section so I thought of away to make a semi permanent way to solve this problem.
I use wire glue to help solder solar cells together so why not paint the outside rail joiners with the wire glue to make the electrical connection?
Let me know your thoughts on this please.