I replied under your post..................

RE: blinking lights.....I had the same problem with my PowerCab....at 2,4,6,8,ect speeds the light was on.....at 1,3,5,7,9,ect the light was off....sooo.....it looked the the lights were blinking on/off as I increased the speed....I inadvertently set the loco to...um...14/28...speed steps....should have been set at 128...I believe...was a while back

I am adding an LED to my DCC board. I have the resistor attached to the LED.....but do not know which leg of the LED goes to the common or output pads?
Thanks

Still couldn't find it.....but I copy and pasted your  file name and ran "search" and found it....saved the icon in my tool bar....THANKS

QuoteI use a program called RR trains.  It can be found at http://www.gregorybraun.com/RRTrains.html

It's not the perfect program, but it's pretty good.  Some of the items can be changed in the registry.

Kevin

Hey Kevin...I downloaded this and I'll be darned if I can find it.....not like me to loose a downloaded item....I still have the install and unzip icon on my desktop, ran them twice....2nd time asked ok to write over old program and I clicked yes....still can't find it!

Never a problem....'cept the April issue.....got 2 each ModelRailroader and Trains!!!! That will increase circulation #'s!

It all up-loaded in seconds for me! Nice photos! Neat youtube!

Ok...thanks for all the replies....I think I'll try out "sound"
They're on sale from an internet supplier I've used before ($100)
Tom

I am thinking of buying one of these....any pro/cons?
Would be my 1st sound unit...I use EZCommand

7 for DCC
5 for DC

I used to watch...But I hate reruns....any new ones out?

Atlas HO Pennsy H16/44....switching........

I'm Both.....half is wired DC...half is wired DCC

Atlas HO Pennsy RS1, chalk/pastel weathered....heading out with a coal drag

I have the EZ Command....and I belong to a club....thats where I go when I need to program a loco...otherwise, the EZ Command works well for my needs.