Joe , Thank you for the reply. I will try CV8 =33
Don
Don
- Welcome to Bachmann Online Forum.
News:
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Discussion / Re: reset to factory setting of Bachmann DCC decoders
August 26, 2014, 03:45:16 PM #2
General Discussion / reset to factory setting of Bachmann DCC decoders
August 26, 2014, 03:03:10 PM
Hello,
I have several Bachmann locomotives with DCC. ( EMD FT A units, Baldwin Sharknose A & B units) After programming the address to a number other than 3, the locomotives no longer run on regular DC. How do I set the decoders back to factory default? Some other decoders are reset by programming CV 8 to a value of 8, but that doesn't seem to work with the Bachmann decoders. I use MRC Prodigy Express.
I have several Bachmann locomotives with DCC. ( EMD FT A units, Baldwin Sharknose A & B units) After programming the address to a number other than 3, the locomotives no longer run on regular DC. How do I set the decoders back to factory default? Some other decoders are reset by programming CV 8 to a value of 8, but that doesn't seem to work with the Bachmann decoders. I use MRC Prodigy Express.
Pages1