ONLINE
STORE
"ASK THE BACH MAN"
FORUM
PARTS, SERVICE,
& INFORMATION
CATALOGS AND
BROCHURES

Welcome, Guest. Please login or register.
Did you miss your activation email?
September 23, 2018, 02:59:43 AM
Home Help Search Login Register
News: Check out the photo gallery link above or >click here< to see photos of recently announced products!
  Show Posts
Pages: [1]
1  Discussion Boards / HO / Re: E-Z Command control center on: December 29, 2017, 03:48:19 PM
Yes Terry--I have two turn outs on one side that permits the train to "come into the yard" and another to permit the train to "leave yard" heading back in the original direction.  They both feed into one track which goes into a cross piece that completes the double loop and yard access. On other end of perimeter track is a turn out that permits train to come into yard from that direction. It feeds into the cross piece to get to the other turnouts on far side.
2  Discussion Boards / HO / Re: E-Z Command control center on: December 28, 2017, 03:36:30 PM
Not exactly sure what you mean by a reverse loop but have perimeter track that goes around a 4x8 wood base, have added 30 inches in length and another 8 feet in width (L-shape). track circles all of this and crosses over two tracks coming into the center of the 4x8.  One of these is connected to the outside perimeter track and other , at the moment, dead ends.
3  Discussion Boards / HO / Re: E-Z Command control center on: December 28, 2017, 11:11:01 AM
Also--no cars on track --nothing across rails --all was working fine earlier --
4  Discussion Boards / HO / Re: E-Z Command control center on: December 28, 2017, 11:08:17 AM
Unplugged from the track it does not show a short--plug it in and lights start flashing.  I have another dc controller that seems to work fine--it shows 4.3 volts to the track.
5  Discussion Boards / HO / Re: E-Z Command control center on: December 22, 2017, 07:28:39 PM
Ok--ran a continuity check on track--getting circuit between rails.  Will have to assume that is the problem--

Any tricks of the trade to check out about 50 feet of track?  Have looked and nothing across them--
6  Discussion Boards / HO / E-Z Command control center on: December 22, 2017, 06:12:21 PM
Hello all--

Am having a problem with my E-Z command control center.
After plugging in and turning on power, all is normal--#1 is on, under stop is on and direction is on--then, after plugging into track all lights star flashing and function goes back to #1--

Have checked track for obstructions, don't knw where there might be a short--have no ideas. 

Any help Huh???

(Was working right before)
7  Discussion Boards / HO / Flex Track Radius on: November 21, 2017, 11:25:41 AM
How tight will a flex track bend ?  I need to make a "U Turn/ turn around" on a board 30 inches wide. Am using Bachman EZ-Track and would like to stay with that if possible.
Pages: [1]
Powered by SMF | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!