ONLINE
STORE
"ASK THE BACH MAN"
FORUM
PARTS, SERVICE,
& INFORMATION
CATALOGS AND
BROCHURES

Welcome, Guest. Please login or register.
Did you miss your activation email?
October 21, 2018, 07:32:13 PM
Home Help Search Login Register
News: Check out the photo gallery link above or >click here< to see photos of recently announced products!
  Show Posts
Pages: [1]
1  Discussion Boards / HO / Re: Bachmann S2, DCC ready on: November 23, 2017, 12:01:44 AM
Okay, I found it as well finally.  That DZ chip is for hard wiring.  My model is DCC ready and other chips are less expensive than this one.
2  Discussion Boards / HO / Re: Bachmann S2, DCC ready on: November 22, 2017, 11:50:00 PM
That chip does not seem to be listed on their website any more.  I guess it is no longer available, unless it is brand new?
3  Discussion Boards / HO / Re: Bachmann S2, DCC ready on: November 22, 2017, 11:38:56 PM
I am looking to use the  DH165IP  chip or a z scale chip that fits.  I will let you know after I get a chip that works.
4  Discussion Boards / HO / Re: Bachmann S2, DCC ready on: November 22, 2017, 11:21:45 PM
I was hoping to not have to remove the shell until it was time to install the chip.  From what I have gleaned from this forum, someone else had the same or similar question.  He decided to use an n scale chip with a long wire harness after trying an HO chip which would not fit under the shell and the n scale chip with the short wire harness did not allow the chip to find a "hiddy hole", but he was successful with the long wire harness.
5  Discussion Boards / HO / Bachmann S2, DCC ready on: November 22, 2017, 09:36:02 PM
I just purchased a S-2 that is DCC ready via eBay.  The model appears to be new in the box as I could not see any wheel wear and the coupler hoses have not been adjusted.  What I am wondering is which DCC chips can be used in this model?  I normally use the Digitrax DCC chip finder program to find a Digitrax chip, but none are listed for this model.  I normally use Digitrax because the model train club I joined uses a Digitrax system.  If another non-sound chip can be used, which one(s)?  I plan on running it with my DCC/sound S2 that I already have, so I do not need sound in both models.....   Thank you.
Pages: [1]
Powered by SMF | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!