ONLINE
STORE
"ASK THE BACH MAN"
FORUM
PARTS, SERVICE,
& INFORMATION
CATALOGS AND
BROCHURES

Welcome, Guest. Please login or register.
Did you miss your activation email?
September 17, 2019, 01:03:51 AM
Home Help Search Login Register
News: Please read the Forum Code of Conduct   >>Click Here <<
  Show Posts
Pages: [1]
1  Discussion Boards / Large / Gear for C-19 on: December 14, 2018, 03:40:57 PM
Has anyone found a replacement gear for the drive axle in a C-19? I'm trying a rebuild with this motorgearbox but Bachman doesn't offer the final drive gear.
2  Discussion Boards / Large / Gear material in Consolidation gearbox on: February 27, 2017, 06:27:49 PM


Hello,
Could you tell me if the gearbox in the C-19 1:20.3 scale engine is metal or not?
I'm contemplating changing gears in an existing engine I have that's had four separate failures. The longest the engine has run is three and a half hours. I'm not going to send another fifty dollar check for gear replacements that clearly don't work. Thanks









1
3  Discussion Boards / Large / Spectrum Consolidation on: May 04, 2010, 06:17:54 PM
 Has there been a revision/update to the gearbox on the Connie? I ask because I've stripped two gears out, the last one after less than ten hours running.
I use the engine at shows our group, the Wisconsin Garden Railway Society participates in. This means that the engine in question runs on a level inside oval with 20' radius curves, pulling 8 to 10 cars at a moderate speed.
The first time I replaced the gear I missed seeing the shaft the first nylon gear rides on, the one that strips, is very loose on both ends where it mates to the gearbox halves. I believe this looseness is what causes the gear to strip out. The motor is solidly mounted to the gearbox and the screws in the gearbox are tight. I LOVE this engine but I'm tired of replacing gears.
Pages: [1]
Powered by SMF | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!