ONLINE
STORE
"ASK THE BACH MAN"
FORUM
PARTS, SERVICE,
& INFORMATION
CATALOGS AND
BROCHURES

Welcome, Guest. Please login or register.
Did you miss your activation email?
September 21, 2019, 07:35:19 AM
Home Help Search Login Register
News: Check out the photo gallery link above or >click here< to see photos of recently announced products!
+  Bachmann Message Board
|-+  Discussion Boards
| |-+  Large
| | |-+  2-4-2 piping
« previous next »
Pages: [1] Print
Author Topic: 2-4-2 piping  (Read 1300 times)
bob kaplan

View Profile
« on: August 09, 2011, 03:37:11 PM »

i did try this in another thread, but there has been no reply....so i thought i would attempt a thread of its own.   When attempting to put a crew in the new 2-4-2, it was easy to remove the screws as shown in the diagrams that come with the engine, so that i could remove the cab.... but i could not remove the piping to completely remove the cab and install the crew.  Can someone give a suggestion or two.
  Thank you.
Logged
Sleeping Bear

A genuine ALCOholic


View Profile
« Reply #1 on: August 09, 2011, 08:21:05 PM »

   If the piping mounts to a hole that comes the whole way through the cab wall, and you can reach it inside the cab with a small paint brush, try a drop or two of acetone. If there is any glue or if there is a paint weld holding the piping in place, the acetone might loosen it. Be VERY careful around paint that you care about. It is very likely that too much acetone will eat paint off though to date I haven't had much problem with this on Bachmann stuff, just don't rub the area, pat it and let dry. Acetone will dissolve most C.A.'s(contact adhesives) like super glue and the like, and may soften paint enough to break its hold.                      Hope this is some help.......S.B.
Logged

"If at first you don't succeed....Get a bigger hammer"
bob kaplan

View Profile
« Reply #2 on: August 10, 2011, 11:47:48 AM »

ok...thank you...i will give it a try.
b
Logged
Pages: [1] Print 
« previous next »
Jump to:  
Powered by SMF | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!