DCC e-z command center to power ez track turnouts.

Started by MrMoose, January 03, 2015, 11:56:20 AM

Previous topic - Next topic

MrMoose

I am using a Dcc Nce power cab on my layout.
What I would like to know if I can use the E-Z command center to just power the turnouts in my layout so not to draw power from the track?

jward

you would be better off using an old dc power pack to power your switches. they will work on wither the ac  or dc terminals.  if your pack doesn't have 12v dc terminals, use the ac ones.
Jeffery S Ward Sr
Pittsburgh, PA

Joe Satnik

MrMoose, 

If your turnouts are DCC controlled, i.e., have stationary DCC decoders built in,

you would need to electrically isolate the internal decoders from the rails of the turnout,

then connect the decoders directly to the extra DCC transmitter.

This kind of defeats their purpose, which is to have only one controller running things,

and it would most likely end their warranties.   

Before you do that, try to improve your track connections by

cleaning and tightening up rail-to-rail connectors,

and adding a track power bus system around your layout.

If those steps don't improve things enough, then consider adding a DCC power booster.

Hope this helps.

Sincerely,

Joe Satnik   

If your loco is too heavy to lift, you'd better be able to ride in, on or behind it.