News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu

Number 4 switch versus regular switch

Started by cwex, May 13, 2017, 09:53:56 PM

Previous topic - Next topic

cwex

What is the difference between these 2 switches.

the Bach-man

Dear CWEX,
A "regular", or "snap switch", is basically a curved section of track laid over a straight section.
A numbered switch is more realistic. The divergent leg is straight as well, and the number
indicates the length of the divergence. Thus, a number four diverges one unit for each four
units of length. (Think rise and run on a roof).
The higher the number the longer the switch, or turnout.
Have fun!
the Bach-man

ACY

The higher the number the better, so #8's would be best for larger locomotives like a 4-8-8-4, 4-6-6-4, or a Bachmann EM-1 2-8-8-4 for instance as well as for 85 and 89 foot cars. #4's would more be suited for 4 axle diesels or an 0-4-0 or 0-6-0 and 40 foot or shorter cars. 18" radius (what you are calling a regular switch) would be about the same category as a #4 but a bit more restrictive.

cwex

Thanx.
I have 2 trains, one that has 22 inch radius track and the other one has 18 inch.
In order to have 2 ovals, connect them with #6 turnouts and then can make spurs off of 18 inch for yards etc?
Thank you for your time and patience.

Len

Here's a basic double loop using 18" and 22" curves, with #6 crossovers. The crossovers can be shifted left or right to suit whatever spurs or yards you want to include. Keep in mind the crossovers are intended for layouts using DCC, not DC. The spacing between the inner and outter loops will be wider using #6 switches, unless the diverging legs are cut back.



Len
If at first you don't succeed, throw it in the spare parts box.