0-6-0T with dcc on board not responding to cv29 long address.

Started by digitalgriffin, February 17, 2018, 12:09:55 PM

Previous topic - Next topic

digitalgriffin

I'm trying to program this engine with a long 4 digital address

I put it on the program track and programmed cv29.  I then confirmed it with a read.

Values I trI'd are 32 36 38 and 34

When I stick it on the main track it only responds to short address.

I know it's reading cv29 because I I set a value of 1 or 255 the Loco runs backwards as it should

Len

You might find this page useful for making sure you're inputing the correct values to CV29 and CV17/18:

http://www.2mm.org.uk/articles/cv29%20calculator.htm

Len
If at first you don't succeed, throw it in the spare parts box.

Hunt

What is being used to program?

A 1000 Ohm, ΒΌ Watt resistor laid across the programming track is required for programming  a factory installed non-sound Bachmann (Lenz based) decoder used with a Digitrax Zephyr (DCS50) or Zephyr Xtra (DCS51).

Remove resistor after programming.