News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu

Bachmanns horse stock car..

Started by smcgill, April 03, 2018, 03:50:55 PM

Previous topic - Next topic

smcgill

Has anyone tried to remove the horses to paint them so they resemble their horses ?


I would like to attempt this..

Loco Bill Canelos

Sounds like a fun project, but I don't know of any diagrams for the car.   I was thinking that you could probably disassemble the car just like you would a standard stock car, and carefully check out the moving mechanism and remove it.  Wondering if you could open the doors and see what is going on inside, maybe you could get a clue from doing that.

No matter when you figure it out take a photo of your real horses and of the car horses after you paint them and post them for us!!

Good luck with the project!!

Bill
Loco Bill,  Roundhouse Foreman
Colorado & Kansas Railway-Missouri Western Railway
Official Historian; Bachmann Large Scale
Colorado RR Museum-Brakeman-Engineer-Motorman-Trainman
There are no dumb or stupid questions, just questions!

smcgill

Bill
Is there an exploded diagram for this car ?   ???

Loco Bill Canelos

I tried to find one but don't think one was posted anywhere and if there ever was one it is not posted on the
Bachmann site that I can find.
Loco Bill,  Roundhouse Foreman
Colorado & Kansas Railway-Missouri Western Railway
Official Historian; Bachmann Large Scale
Colorado RR Museum-Brakeman-Engineer-Motorman-Trainman
There are no dumb or stupid questions, just questions!

Loco Bill Canelos

Did you have any luck figuring out how to get it apart??
Loco Bill,  Roundhouse Foreman
Colorado & Kansas Railway-Missouri Western Railway
Official Historian; Bachmann Large Scale
Colorado RR Museum-Brakeman-Engineer-Motorman-Trainman
There are no dumb or stupid questions, just questions!

BillBrakeman

To disassemble the animated stock car is fairly easy. The floor of the car has 8 tabs, four on each side, that go into slots on the body of the car. Start in the middle of the car and spread the body of the car until the center tabs clear and then free the other tabs and lift the body off.  The livestock heads are screwed to the center, swinging beam and can be removed to work on the heads individually.

Bill :)

smcgill