ONLINE
STORE
"ASK THE BACH MAN"
FORUM
PARTS, SERVICE,
& INFORMATION
CATALOGS AND
BROCHURES

Welcome, Guest. Please login or register.
Did you miss your activation email?
November 20, 2019, 06:04:44 AM
Home Help Search Login Register
News: Please read the Forum Code of Conduct   >>Click Here <<
+  Bachmann Message Board
|-+  Discussion Boards
| |-+  General Discussion
| | |-+  EZ Command Programmed Locos on Another System
« previous next »
Pages: [1] Print
Author Topic: EZ Command Programmed Locos on Another System  (Read 409 times)
glennhazel

View Profile
« on: June 26, 2018, 09:44:45 AM »

I use an EZ Command system. When I visit another layout, I need to encode a new address for the loco.  Could I just use the EZ command address, say #5, on the other system. Most likely NCE.
Logged
the Bach-man
Administrator


View Profile
« Reply #1 on: June 26, 2018, 09:28:45 PM »

Dear Glenn,
That would depend upon whether the address is available on the railroad you visit.
If your host changes your loco to a four digit address (typically the cab number) remember to have it changed back to 5 when you leave.
Have fun!
the Bach-man
Logged
glennhazel

View Profile
« Reply #2 on: June 27, 2018, 06:15:57 AM »

My loco is programmed as #5 on EZ Command. Would I be able to use it as #5 on another system?

If is is there a list of addresses that correspond to the buttons on EZ Command?

NCE shuts down the main while the programming track is in use. If I arrive during an operating session I am out of luck of being able to run my engines. If I knew the button addresses I could just use that address if it is not already assigned to another engine.

Glenn
Logged
Pages: [1] Print 
« previous next »
Jump to:  
Powered by SMF | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!