Welcome, Guest. Please login or register.
Did you miss your activation email?
August 08, 2020, 10:38:12 PM
Home Help Search Login Register
News: Check out the photo gallery link above or >click here< to see photos of recently announced products!
+  Bachmann Message Board
|-+  Discussion Boards
| |-+  General Discussion
| | |-+  Keep alive
« previous next »
Pages: [1] Print
Author Topic: Keep alive  (Read 435 times)

View Profile
« on: October 19, 2018, 05:34:56 PM »

Does anyone know the soldering points on the DCC logic board for putting a Keep Alive on a Bachmann service truck that runs on the rail?

View Profile
« Reply #1 on: October 19, 2018, 11:48:51 PM »

The common power lead, blue lead and the minus logic power. Notice, there is no ground on a decoder regardless of what some say. Only plus and minus 12 to 14v  I would look at the output of the full wave bridge.
Below is a good link about this issue. He does point out other areas. Shrink wrapped can be an issue.

Technical info.

Realize, stay alive is a two edge sword. The loco can continue to run even if the DCC system is shut off. Some have had a collision, run a loco into a TT pit, onto the floor, collision between two locos with some damage., etc. I have seen this discussed  in a few forums. The keep alive keeps power to the decoder. No way to shut the keep alive off. The keep alive has to bleed off.
Check the second link and see how long some keep alive last. It might not happen much but the potential is there.

« Last Edit: October 20, 2018, 12:02:31 AM by rich1998 » Logged
Pages: [1] Print 
« previous next »
Jump to:  
Powered by SMF | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!