Help with ez command control centre

Started by Andyb60, January 18, 2019, 07:05:09 AM

Previous topic - Next topic

Andyb60

Hi
I have an ez command control centre on a small n gauge layout, and suddenly the train has started running erratically.
The model is not responding to to control inputs on speed and direction changes, and now appears to run the same on any channel (it was originally assigned to 3).
Any ideas or Has the unit developed a fault?

Flare

Sadly, the EZ Command Control Center is a 'simple' DCC controller.

One of its shortcomings is that it cannot reset malfunctioning decoders.  (Typically by setting CV 8 to 8)

See if a hobby shop, club, or individual in your area has another DCC controller and maybe they can help you.

Andyb60