Labels on PCB01A for n scale Peter Witt street car

Started by gbrown50613, July 31, 2020, 05:39:51 PM

Previous topic - Next topic

gbrown50613

I am trying to figure out the 7 solder connections on the printed circuit board on the dcc decoder. They are labeled M+, M-, R, L, L+, 1- and 2-. Some of these are obvious such as the M+ and M- for the motor. I am thinking that the R and L are the electrical pickups from the trucks. Not sure on the L+ and the 1- and 2- but two have to be for the front and rear lights.

Piyer

R:    Right Rail
L:    Left Rail
M+: Motor Brush Connected to Right Rail
M-:  Motor Brush Connected to Left Rail
L+:  Light Positive
L-:   Light Negative

Source: https://www.bachmanntrains.com/home-usa/board/index.php?topic=34392.0;wap2
~AJ Kleipass~
Proto-freelance modeling the Tri-State System c.1942
The layout is based upon the operations of the Delaware Valley Railway,
the New York, Susquehanna & Western, the Wilkes-Barre & Eastern,
the Middletown & Unionville, and the New York, Ontario & Western.