Resetting to 3

[taycotrains]

Another problem...

I have a GE 70 Tonner that was purchased used.

The engine runs fine on a analog track,but does not respond to any
address on the EZ commander.
Is it possible someone assigned it to address on another dcc set up the the EZ Commander does not recognize ?

Is it possible to reset to factory address #3.

Thanks
Bob

[pdlethbridge]

usually resetting cv 8 to 8 will restore factory settings. Have a friend do it that has a more advanced system than ez command

[taycotrains]

Oh Boy !

Looks like I better get a better "class" of friends...all my friends run there trains
with ZWs 

Thanks for the tip Ill see if I can find someone.

Bob T

[Hunt]

If the locomotive has a digital address higher than 10, you can reprogram it to a new number. Carefully follow the procedure on page three of the E-Z Command Setup and Programming Instructions under REPROGRAMMING DECODERS WITH PREVIOUSLY ASSIGNED DIGITAL ADDRESSES.



Lost the instructions click  http://www.bachmanntrains.com/home-usa/ez_content/EZ_Command_instructions.pdf

[taycotrains]

Thank you Hunt !

I followed the directions that my daughter printed out and the engine is reset to 3
BT