DCC for older Bachmann Spectrum 44-Ton Switcher

[NSguy]

Any suggestions for a decoder for  an older Bachmann Spectrum 44-to switcher? 

[electrical whiz kid]

You are looking at an extremely challenging proposition.  These locomotives are none too flush with room.  Personally, I would suggest toying around with an 'N'scale decoder.  The motors and the other innards aren't all that big, thus not too demanding for wattage, so check this thought out.  I have two Mantua Camelbacks, and did just that with them.  I also have a Keystone GE 44-ton switcher... I have as yet to get up the nerve...  A watchmaker I am not!

Rich C.

[RAM]

Now you say older, the question is.  How old.  If it is the old 2 motor job, than you have you work cut out for you.

[Len]

Don't know if it's the version you've got, but installation pics for one version can be found at:

http://www.tcsdcc.com/Customer_Content/Installation_Pictures/HO_Scale/Bachmann/GE_44_Ton/Bachman%20GE%2044%20Ton%20Diesel%20Switcher.htm

You can use any small decoder rated for at least an amp and the pics at least show which color wire goes where on this version.

Len

[NSguy]

This looks like a good place to start.  I haven't removed the shell yet so I'm not sure which version I have.  Thanks for the help.
Bob Hayden