I fried the lights of the dummy engine a few months back and would like to replace them...need the circuit board and wires and light board
ok thanks but the board on mine has the leds made onto it...not bulbs with wire
Quote from: full maxx on December 13, 2010, 11:53:44 AM
ok thanks but the board on mine has the leds made onto it...not bulbs with wire
Are you talking about the N scale version?
no this is the ho board
Quote from: full maxx on December 14, 2010, 12:13:20 PM
no this is the ho board
The bulbs should be wired to the board with wire leads. The wire leads have to be de-soldered from the pc board and the replacements soldered to the same location.
I've seen all variants of the drives and pc boards but I haven't seen any of the pc boards where the leds are directly on them. I'm assuming you mean that there's no easy way to remove the wires without soldering :-\
I have thrown away the board that was in the dummy engine but the bulbs were made onto the board without wires and they were square