Is there a video on how to file bachman turnouts? I'm having derailpromblems I can't seem to fine a video on that. Any help? Thanks.

The L10 steam I have is a 2_8_0 would that make any difference on the 18 or 22" bachman curves?

Can a L10 steam locomotive run on 18"and22" bachman track?

Ok.this for the reply.

Will it cause problems mixing bachman steel track with bachman nameplate track

The color bands on the resistor as from what I can tell are red green brown.does that make sense?  I like the block lights just to show the direction of the turnout.hope that makes sense to you.I'm new at this.this.

Anyone tell me what I'm going to need to put power to this block signals.they are a two led light signals. There were no instructions. There is a green wire a red wire and w black wire with a resistor on the end.any help?

To flair and Terry t. Got the revere s loop working. My Bachman engine and my mth engine goes threw the revere s loop with no stoping. Hooked it up to my mth base command, still works good.I'm so happy. Thks.to you guys for all your help. This made my day😃😃😃😃😃

Flare,I'll try to get that picture to you.

No Terry t. I don't have separate power to the loop itself,I have a 100watt power brick that supply the power to the whole track layout.don't you think that should be enouhg? I don't have my turnouts wired up to power should I do that? Ps my layout is only 6x8.

Joints seem to be tight.but I'll ck.again. If they are tight, what else could it be?? Tks flare.

About 8"

I'm useing Bachman e-z automatic reverse loop command module,with 2 9" insulated gap tracks. The engine goes threw one turnout into the loop partway but then stops. do I need to have a nother module hooked to the other insulated gap track? Any help?tks.   

Want to thank everyone for your comments.most helped me a lot.you can tell I'm new at this . I'm a retired truck driver and wanted to get into model trains .something to keep me busy.once again thks.

I do have a bachman e-z command control. I'll hook that up to the reverse loop to see if that works without my engine shutting down