BACH -Man; what is the scheduled delivery of the F7 DCC & SOUND Locos ?  Any word yet?

          Sounds like the engine/engines have dropped from the speed step setting some how. There is a " CV " for engine speed built in to the DCC card in each engine. I'm no genius on DCC , but, that's what I think.
           To reset you need to have a controller capable of setting CV' s .

      By the red engine I assume it is the FTA Sante Fe . Check the trucks, make sure the side frames are snapped in place and not binding on wheels/gear. While your checking eyeball the drive gears in both trucks.You can lube the gears with some Silicone oil or an oil that is plastic compatible.If you find damaged gears submit the engine for repair or replacement.

   
          Does anyone know the minimum radius for the #50901 Berkshire loco? I have checked on line catalog without luck. Thanks

      Thank you for the speedy reply.

      Does anyone know minimum track radius for this Loco ?

   I have Bachmann GP40,GP38-2 and a FT-A All are DCC controlled. What I was wondering is if there are sound decoders available for each of them and would a sound unit fit in these locos.Has anyone done this? your input is appreciated.

    No I haven't tried OPS mode only because the Digitrax manual said to use Page on a programing track. The 10k resistor wasn't used since it is suggested to use it when the when the new address is not recognized by the programmer.If the system did not recognize the entry then why could it go back to the old address and operate the loco?
     There is not any logic.   

         Info needed; I tried changing the address on my Bachmann GP40 ,DCC loco, from a two digit to a four digit and it seems to accept the change,but,it won`t function.However,when I go back to two digit (02) it works.Tried this several times and had same results.
         I am using a "Digitrax Zephyr Xtra" Dcc control system on a program track as per Digitrax instructions. Anyone have advice to give?

        I guess that is what I'll have to do.Just figured that if Bachmann is supplying it with other items that it would have a part # and could be purchased separately.
        Thank you for your efforts to help me.

       I appreciate your reply,but,the BAC00002 is not the correct one. this does come with the DCC sets,however, the sets come with an additional Power connector wire that has "U" shaped terminals that hook up to screw type transformer terminals instead of the phono style plug. The BAC00003 has the wire I am looking for and cannot find part # for it. If anyone knows the part# for it,please supply.   

     Does anyone have a part number for the Red Universal power connector that comes with the Digital Command sets. I cannot find any reference on Bachmann site.

                 Thank you for the info,very helpful.

           Anyone know item # for the N/S E-Z track 18" curved re-railer w/power connector? the re-railer w/o power connector is 44529.
It is mentioned in description of non-powered type. to use with DCC power.

       Thank you for the quick replies,it is appreciated. Happy New Year!