Hi Mr.Bachmann , I have recently purchased some 44132 and 44133 DCC E-Z Track turnouts , when fitting other track components i.e. 44511 straights , have found that the roadbeds, foul on the track beside it .. Question is do I have to trim the roadbed on both tracks , if so , by how much and at what angle is recommended ?

Spencer-

Look at the undersides of the turnouts. You will see guide lines for removing roadbed areas so you can connect the diverging routes to other tracks.
                                        -- D

Thank you  , shortly after I sent this message , I inadvertently held one of the short sections of track supplied with the turnouts up to some light and found the cutout markings..
Stupid me...

Quote from: Spencer on April 13, 2014, 04:13:26 PM
Thank you  , shortly after I sent this message , I inadvertently held one of the short sections of track supplied with the turnouts up to some light and found the cutout markings..
Stupid me...

No, just still learning