Siemens SC 44 Charger not Recognizing factory set address

Started by CNR6060, March 14, 2023, 07:56:29 PM

Previous topic - Next topic

CNR6060

I recently purchased a Bachman Amtrak Cascades SC44 Charger Locomotive, However when I put in the factory set DCC address (which was supposed to be set at 3), The address was not recognized, I tried putting in the road number too (1400) But that didn't work either. Has anyone else had this problem?

jonathan

CNR,

Yes. Depends upon your programming system. You can try laying a 1K resistor across your programming track.  That usually gets Bachmann locos to respond to most systems.  Good luck!

Regards,

Jonathan